( 22 / 58 )
Chapter 3. Setting Up
To use this emulation pod with your target system, it is necessary to set as follows. Set the following
after removing the upper cover.
• Change the oscillation frequency.
• Change the switch setting of the internal peripheral circuit.
• Install the A-D conversion bypass capacitor.

3.1 Removing the Upper Cover

The procedure of removing the upper cover is shown below.
(1) Remove the four screws of both sides of this product and lift off the upper cover (see Figure 3.1).
(2) Set the jumper switches.
(3) Replace the upper cover and secure the four screws.
Figure 3.1 Removing the upper cover
CAUTION

When Removing the Upper Cover:

• Always shut OFF power when removing the upper cover or setting the switches.