Revolabs 02-DSKSYS Using with TableTop Microphone, Using with XLR Microphone Wireless Adapter

Turning the dial towards the earpiece, as shown in the figure, will increase the volume, and turning the dial towards the microphone will decrease the volume. Use the attached clothing clip to secure the earpiece wire.

Using with TableTop Microphone

The Revolabs Solo™ TableTop Wireless Boundary Microphones enable multiple phone conference participants to use a single microphone. Units are placed strategically on the conference table to ensure that all participants can be heard clearly.

1.Mute Button — press to mute, un-mute and pair microphone.

2.LED display — visual status for mute, un-mute, and pairing.

3.Integral grille — protects internal parts (non-removable).

4.Audio jack — accepts a 2.5mm plug for a powered speaker.

5.Charging port — docks to all Solo Charger Bases.

6.Rubber feet — non-slip, vibration absorbing pads.

To use the Wireless TableTop Microphone:

1.Remove the microphone from the Charger Base. The microphone turns on and mutes automatically when removed from Charger Base (flashing RED

LED), to reduce noise while placing the microphone on the table.

2.TableTop microphones should be centered on the table with the integral grill pointed toward the users (uni-directional), or centrally located between users (omni-directional), from 2 to 5 feet (.75 to 1.75m) away. It is always better to be as close to the person speaking as possible, but avoid placing the microphone where it might be blocked by equipment or meeting paperwork. Also do not place microphones too close to an audio or video conference speaker to avoid echoes.

3.With the microphone in position, un-mute the microphone by pressing and releasing the MUTE button (confirm by viewing flashing GREEN LED).

4.To turn microphones off, return the microphone unit to the Charger Base. The Microphone LED will show a 5 second self-test pattern and begins charging (solid RED or GREEN LED). Alternately, press and hold the MUTE button for 10 seconds until the LED turns solid RED, then release the mute button and the LED will turn OFF.

If the microphone is moved out of range of the Charger Base (~65 feet or 20m) the connection will be dropped (LED flashes all colors) and the microphone will mute.

After 15 seconds the microphone will beep 5 times, and will continue beeping every 30 seconds to remind the user to return the microphone to the conference room. If the microphone is moved back into range within 15 minutes the connection will automatically be re-established to its original state, and the beeping will cease. If not, the microphone will turn off.

Using with XLR Microphone Wireless Adapter

The Revolabs Solo™ Universal Wireless Adapter for Handheld Microphones, shown in the following figure, is connected to your existing handheld dynamic

14 15