Changing Channels:

To change channels, simply depress the Toggle/Standby switch momentarily until the LED for the desired channel pattern is lit up. Remember to change the receiver channel as well, since it is not automatically changed when the transmitter channel is changed.

INTERFERENCE

If interference such as lines in the pictures is observed, changing the transmission

channel may cure the problem. In some cases strong signals from wireless network could cause the problem Also, AC generators in close proximity to the transmitter or receiver may cause lines

in the picture. Move the unit away from the source of the interference.

NO PICTURE

Check that the transmit and receive channels are set the same.

Verify all connectors are tight.

POOR PICTURE QUALITY

Raise transmitter and receiver antennas above ground and away from obstacles and

traffic, including foot traffic. Change the channel or check with a spectrum analyzer if any other source transmitting. Use only clear channel, not disturbed by other transmitting source.

Use an optional high-gain dish antenna on the receiver. Verify all connectors are tight. Shorten the receiver antenna feed cable.

RADIO SECTION:

Frequencies:

Channel 1: 2300 MHz

Channel 2: 2325 MHz

Channel 3: 2350 MHz

Channel 4: 2375 MHz

Channel 5: 2410 MHz

Channel 6: 2433 MHz default channel

Channel 7: 2452 MHz

Channel 8: 2481 MHz

RF Output Power: Nominal: +35dBm ± 3 dB conducted into 50 Ω unmodulated carrier with final PA on.

Frequency Stability: 0.005% PLL Stabilized (50 ppm) over temperature range

Frequency Plan: Single upconversion with SAW IF filter for bandlimiting, Low Side LO injection, 479.5 MHz IF

Modulated Bandwidth: 16 MHz (3 dB); 30 MHz (40 dB)

Harmonic Attenuation: > 20 dBc (2nd harmonic)

Spurious Attentuation: > 50 dBc

VIDEO SECTION:

Input Level: 1Vpp per NTSC/PAL standard

Input Impedance: 75Ω unbalanced

Modulation: Narrowband direct FM (for composite signal)

Modulation Index: 1.0 at 6.5 MHz for composite A/V signal (±6.5 MHz deviation)

Pre-emphasis: CCIR Rec 405-1

AUDIO SECTION:

Input Level: 1 Vpp Nominal

Input Impedance: 600 Ω

Bandwidth: 50 Hz – 10 kHz (3 dB)

Modulation: Wideband FM

Subcarriers: 6.0 MHz and 6.5 MHz

Modulation Index: 1.0 at 11 kHz for audio (±11 kHz deviation)

Pre-emphasis: yes

GENERAL:

Size: 3.4”W x 4.3”L x 1.2”D (8.64cm x 10.9cm x 3.05cm)

Weight: 1.5 lb (0.68 kg)

Page 3
Image 3
RF-Link Technology XL-2000/H Interference, No Picture, Poor Picture Quality, Radio Section, Video Section, Audio Section