RF-Link Technology XL-2000/H Audio Inputs, Power Input, Video Output, Audio Output

3) Do not add additional lengths of cable to connect the receiver to the antenna as significant losses in signal, and reduced transmission range will occur.

4) Keep the cable connecting the antenna to the receiver as short as possible.

5)If needed you may run over 100 ft coax audio/video cable feed to the A/V source

IMPORTANT NOTE:

The Transmitter and Receiver units may get warm to the touch. This is normal and does not affect operation in any way. Units are covered by one-year warranty.

WARRANTY VOID IF UNITS MODIFIED!

Figure 2 shows the front panel of the XL 2000/H transmitter and the functions of each control and input/output. Each control is described in greater detail below.

IMPORTANT NOTE: The transmitter uses a non-standard (SMA) jack to connect to the transmitter to antenna. Any modification to this jack may void the user’s authority to operate the equipment and will void the manufacturer’s warranty.

AGAIN: DO NOT APPLY POWER TO THE TRANSMITTER WITHOUT THE ANTENNA SECURELY ATTACHED- DAMAGE TO THE UNIT MAY RESULT.

VIDEO INPUT

Designed to mate to a standard BNC male connector, this input accepts 1 Volt peak-to- peak video in both NTSC and PAL formats. This input is terminated with 75 Ω.

RCA to BNC adapters are available for use with some cameras and VCRs.

AUDIO INPUTS

There are two separate audio inputs/outputs for stereo audio broadcast.

Designed to mate to a standard RCA male connector, this input accepts 300 milivolt peak-to- peak audio input and is terminated with 600 Ω unbalanced configuration.

It is designed to be interfaced to “lineout” audio sources. A preamplifier must be used to connect a microphone to this input. RCA to BNC adapters are available for use with some cameras and VCRs.

IMPORTANT NOTE:

With no video signal input, the transmit power level will be reduced in compliance with FCC regulations, shortening the transmission range for audio significantly. A video signal must be present on the video input

to allow transmission at full power.

POWER INPUT

Accepts a 12 Vdc power source such as the standard 12 Vdc adapters or an optional battery. The nominal current draw is 280 milliamperes for the receiver part and 1.5 A for the transmitter part. If using an adapter from a third party, use a well-regulated 12Vdc/500mA output supply for the receiver and 1.6 A/12 V well regulated for the transmitter unit.

Changing Channels:

To change channels, simply depress the Toggle/Standby switch momentarily until the LED for the desired channel pattern is lit up. Remember to change the receiver channel as well, since it is not automatically changed when the transmitter channel is changed. In order to change the channel please read the text bellow.

NOTE: MODEL XL-2000H/2 HAS SWITCH FOR THE TRANSMITTER INSIDE THE BOX. CAREFULLY OPEN THE UNIT AND LOCATE SMALL PUSH-BUTTON SWITCH WITH LED DIODE. YOU CAN CHANGE THE CHANNEL FROM 1-8. THE RECEIVE PART HAS A SWITCH WITH 8 CHANNELS- PLACE DESIRED CHANNEL TO ON POSITION.

VIDEO OUTPUT

Designed to mate to a standard BNC male connector, this provides a 1 Volt peak-to-peak video signal output. This must be terminated with 75 Ω. RCA to BNC adapters

are available for use with some monitors and VCR inputs.

AUDIO OUTPUT

Designed to mate to a standard RCA male connector, this provides a 1 Volt peak-topeak audio output and should be terminated in a 600 Ω load, as is found in most “line

in” audio inputs. RCA to BNC adapters are available for use with some monitors and VCR inputs.