5. For Units With a Timer
Timer Functions
A.Clock
B.Timer STD/AUTO
C.Set Sleep Delay Time*
D.Set ON/OFF Times*
E.Filter Life
i.Remaining Life
ii.Filter Reset
iii.Filter Life
F.Service Menu
*ON/OFF times & Sleep Delay Time only operate in AUTO Mode.
To select a Timer Mode
Press the (Prog) button until the desired mode is displayed on the screen. Press the (Accept) button to confirm selection. Pressing (Cancel) button at any time returns the unit to the main menu. Any functions previously accepted will be retained.
Note: The display will revert back to main menu from any mode if a button has not been pressed for 1 minute.
A) Setting the Clock
Select the clock mode (Prog>Clock>Accept)
Display Shows: “Set Clock Day”. Press the (UP) button until the desired day appears on the screen and press the (Accept) button to confirm selection.
Display Shows: “Set Clock HOUR” Press the (UP) button until the desired hour (24 Hour Time) appears flashing on the screen and press the (Accept) button to confirm selection.
Display Shows: “Set Clock MIN”
Press the (UP) button until the desired minute appears flashing on the screen. Press the (Accept) button to confirm selection and the display reverts to the main menu.
8.
B) Set Timer to STD/AUTO Mode
Select the Timer STD/AUTO mode (Prog>Timer STD/AUTO>Accept)
Display Shows: “STD”
Pressing the (UP) button alternates the “STD”/“AUTO” icons. STD operation means that the unit operates 24 hours a day, Auto mode reverts the unit to operate at the pre set times on the timer. Press the (Accept) button to confirm selection and the display reverts to the main menu. If the timer is in AUTO mode, pushing any Timer key will reactivate the unit. The unit will operate normally until the next programmed “Off” time.
C) To Set Sleep Delay Time.
Select the Sleep on/off mode (Prog>Sleep DelayTime>Accept)
Display Shows: “Sleep DelayTime” “ OFF”.
The sleep function puts the unit in a standby mode after user defined period. The Sleep Delay will be factory set to OFF as the default setting. Pressing the (UP) button increases the delay time up to 6 hours. Press the (Accept) button to confirm selection and the display reverts to the main menu. The unit will go into “Sleep” mode if it has not been used for the “Sleep Delay Time” period. To exit “Sleep”, push any Timer key.
D) To Set ON/OFF Times
Select the Timer ON/OFF mode (Prog>Set ON/OFF times>Accept)
Note: to set the unit to be in off mode for an entire day, set the “on” and “off” times to be the same eg: On = 0:00 Off = 0:00
Display Shows: “SUN” “7:00 – 7:00” “Set ON hour”.
Press the (UP) button until the desired hour appears on the screen and press the (Accept) button to confirm selection.
Display Shows: “SUN” “7:00 – 7:00” “Set ON minute”.
Press the (UP) button until the desired minute appears on the screen and press the (Accept) button to confirm selection.
