![](/images/new-backgrounds/1042182/4218217x1.webp)
Electrical Connections continued.
!CAUTION: The presence of water in the piping and water heater does not provide sufficient conduction for a ground.
A separate branch circuit with copper conductors, over current protective device and suitable disconnecting means must be provided by a qualified electrician.
All wiring must conform to local codes or latest edition of National Electrical Code ANSI/NFPA 70.
The water heater is completely wired to the Electrical Power Hookup Terminals inside the jacket at the top front of the water heater. An opening for 1/2″ or 3/4″ electrical fitting is provided for field wiring connections.
The voltage requirements and wattage load for the water heater are specified on the rating plate on the front of the water heater.
The branch circuit wiring should include either:
Metallic conduit or metallic sheathed cable approved for use as a grounding conductor and installed with fittings approved for the purpose.
•240V 1PH
•21.5 Max. AMP draw
•10 gauge wire
•Minimum 30 AMP circuit
!WARNING: If local codes require external application of insulation blanket kits the manufacturer’s instructions included with the kit must be carefully followed.
Insulation Blankets
Insulation blankets, available to the general public, for external use on electric water heaters are not necessary. The purpose of an insulation blanket is to reduce the standby heat loss encountered with storage tank heaters. This water heater meets or exceeds the National Appliance Energy Conservation Act standards with respect to insulation and standby loss requirements making an insulation blanket unnecessary.
The manufacturer’s warranty does not cover any damage or defect caused by installation, attachment or use of any type of energy saving or other unapproved devices (other than those authorized by the manufacturer) into, onto or in conjunction with the water heater. The use of unauthorized energy saving devices may shorten the life of the water heater and may endanger life and property.
The manufacturer disclaims any responsibility for such loss or injury resulting from the use of such unauthorized devices.
!CAUTION: If local codes require the application of an external insulation blanket to this water heater, pay careful attention to the following so as not to restrict the proper function and operation of the water heater:
Do not cover the operating or warning labels attached to the water heater or attempt to relocate them on the exterior of insulation blanket.
Do not apply insulation to the top of the heat pump.
Filter | Top of Heat Pump |
Coils
Do not cover the coils around the sides of the heat pump.
Do not cover the access door to temperature control, temperature and pressure relief valve or drain valve.
Inspect the insulation blanket
frequently.9