ASSEMBLY
Connecting Quick Attach Device (Optional)
Attaching Quick Attach and Bucket to Loader
Refer to Figure Asm-L-0165.
1.Insure bucket is on firm and level ground. Remove pins (13) and retaining hardware (14, 15 & 16) from quick attach.
2.Align boom pivot with bottom hole or quick attach secure with pin and retaining hardware.
3.Align
When Connecting an Attachment to the Loader Quick Hitch
1.Be sure both quick hitch pin levers are in the unlocked position, with the levers pointing up. Tilt the loader quick hitch forward, drive the loader into the attachment bracket and engage top of the quick hitch into the top of the attachment bracket.
2.Raise the loader slightly and rotate the top of the quick hitch back toward the operator until the bottom of the attachment is seated firmly in the bottom of the quick hitch.
3.Rotate the quick hitch pin levers down 90 degrees to the locked position. You should feel a firm resistance when locking the levers down. The tapered pins must extend through the slots in the bottom of the attachment bracket. The tapered side of the pins must be firmly wedged against the surface of the slot at the bottom of the attachment bracket. If the pins are not wedged securely in place, the attachment may fall off resulting in possible severe crushing injury or death to the operator or bystander.
4.Raise the loader and attachment to shoulder height. By standing at the side of the loader, inspect the connection between the quick hitch and attachment.
Never walk or work under or allow any person to be underneath a raised loader or attachment.
ASSEMBLY
1594 01/11 | Assembly Section |
© 2011 Alamo Group Inc.
