Rhino Mounts 1594 manual Assembly, Pre-Operation Check

ASSEMBLY

ASSEMBLY

•Examine the fit between the quick hitch and the bottom of the attachment bracket. The pins must extend through the slots in the bottom of the attachment bracket. The tapered side of each pin must be firmly wedged against the surface of the slot on the bottom of the attachment bracket. The attachment bracket should fit snugly against the bottom of the loader bracket. If there is a gap of more than 1/8” or if the pins are not firmly seated do not use the attachment. Contact your dealer before using the attachment.

5.On level ground, tilt the attachment down 90 degrees and lower it to the ground. Lower the loader further to slightly raise the front of the tractor of the tractor off the ground. Drive the tractor in reverse while the attachment is on the ground for 20-30 feet to insure the attachment does not disconnect. If the attachment disconnects during this process, discontinue the use of attachment and contact your dealer.

Pre-Operation Check

1.Adjust front wheel tread setting stops, if necessary, to provide a minimum 3/4” clearance between front tires and any part of loader with lift cylinders fully oscillated. Be sure lift cylinders are fully retracted.

2.Lubricate all grease fittings with SAE multi-purpose grease.

3.Check hydraulic fluid level in tractor. Fill to recommend level, using oil specified in tractor operator’s manual.

1594 01/11 Assembly Section 3-8

© 2011 Alamo Group Inc.