Manuals / Rhino Mounts / Lawn and Garden / Lawn Mower

Rhino Mounts 1594 manual Assembly, Dismounting the Loader, NOTE Do not relax bucket Cylinders

Models: 1594

1 102

Download 102 pages 10.85 Kb

Page 43

Dismounting the Loader

ASSEMBLY

Dismounting the Loader

1.Locate tractor and loader on firm level ground.

2.With bucket raised above ground, tilt bucket down approximately 30 degrees from level.

3.Lower boom by retracting lift cylinders to lift tractor front end (tires can be off ground).

4.Stop Engine. Allow tractor front end to lower by relaxing ONLY lift cylinders with control lever. This will remove pressure on hitch pins (See Figure Asm-L-0002).

NOTE: Do not relax bucket Cylinders.

5.Set parking brake. Rotate parking stands from storage position by removing lynch pins and clevis pins. Reinstall clevis pins and lynch pins when parking stands are in operation position (See Figure Asm-L-0001).

6.Remove lynch pins and 1” hitch pins from loader upright.

7.Start tractor engine and release brakes. Retract bucket cylinders to allow parking stands to contact ground.

It is important not to put excessive weight on parking stands with lift cylinder retraction. Damage may result.

8.Extend lift cylinders 6” to 8” to rotate top of loader uprights forward out of the mount, allowing tractor to be pushed rearward. Retract bucket cylinders until lower loader upright pins clear mount pin saddles and front tires (See Figure Asm-L-0003).

9.Move tractor rearward approximately 6”, being certain not to stretch hydraulic hoses.

10.Stop tractor engine and set parking brake. Relax lift cylinders and bucket cylinders by moving each control lever in both directions. Disconnect hydraulic hoses from tractor.

11.Start tractor engine and release brakes. Slowly back tractor out of loader.

ASSEMBLY

1594 01/11

Assembly Section 3-9

© 2011 Alamo Group Inc.

Image 43

Rhino Mounts 1594 manual Assembly, Dismounting the Loader, NOTE Do not relax bucket Cylinders

Contents

RHINO LOADER1594 OPERATOR’S MANUALTo the Owner/Operator/Dealer INTRODUCTION SECTION TABLE OF CONTENTSSAFETY SECTION ASSEMBLY SECTIONMAINTENANCE SECTION Safety Section SAFETY SECTIONSAFETY SAFETYGeneral Safety Instructions and Practices SAFETY SAFETYSG-4 SAFETYSAFETY Operator Safety Instructions and PracticesSAFETY SAFETYSAFETY SAFETYEquipment Operation Safety Instructions and Practices SAFETY SAFETYSG-36 SAFETY SAFETYSAFETY SAFETYSPU-2 SAFETYSAFETY SL-33SAFETY SAFETYSAFETY SAFETYSAFETY SAFETYTransporting Safety Instructions and Practices SAFETY SAFETYMaintenance and Service Safety Instructions and Practices SAFETY SAFETYConcluding Safety Instructions and Practices SAFETYSAFETY Storage and Parking Safety Instructions and PracticesSAFETY SAFETYDecal Location LEVEL SAFETYSAFETY NOTE Order D438 Safety Decal Sheet which includes all safety decalsSAFETY SAFETYDecal Description SAFETY SAFETYInspect hoses regularly. Failure to inspect and replace worn hoses may allow them to rupture suddenly and violently, resulting in serious bodily injury or death from scalding, fire burn injury, or oil penetration SAFETY SAFETYSAFETY SAFETYTo Avoid Serious Injury or Death This Act Seeks SAFETYSAFETY Employer-Employee Operator RegulationsPage Introduction Section INTRODUCTION SECTIONINTRODUCTION INTRODUCTIONINTRODUCTION INTRODUCTIONINTRODUCTION INTRODUCTIONINTRODUCTION INTRODUCTIONAttention Owner/Operator Page Assembly Section ASSEMBLY SECTIONASSEMBLY ASSEMBLYGeneral Information Pallet Component Removal ASSEMBLYASSEMBLY Preparing TractorInstalling Grille Guard ASSEMBLYASSEMBLY Installing Left and Right Midmounting BracketsPlumbing Loader ASSEMBLYASSEMBLY Chart Port IdentificationASSEMBLY ASSEMBLYAttaching Bucket to Loader When Connecting an Attachment to the Loader Quick Hitch ASSEMBLYASSEMBLY Connecting Quick Attach Device OptionalASSEMBLY ASSEMBLYPre-Operation Check NOTE Do not relax bucket Cylinders ASSEMBLYASSEMBLY Dismounting the LoaderASSEMBLY ASSEMBLYMounting Loader Operation Section OPERATION SECTIONOPERATION OPERATIONRHINO 1594 LOADER OPERATION INSTRUCTIONS 1594 1. Standard Equipment and SpecificationsOPERATION OPERATIONOPERATION OPERATION2. Operator Requirements OPERATION OPERATIONOPERATION OPERATIONPERSONAL PROTECTIVE EQUIPMENT PPE 3.1 ROPS and Seat Belt OPERATIONOPERATION 3. Tractor Requirements3.3 Tractor Ballast OPERATIONOPERATION 3.2 Tractor Lighting and SMV Emblem3.4 Tractor Ballast OPERATIONOPERATION 4. Getting On and Off the TractorOPERATION OPERATION4.2 Dismounting the Tractor OPERATION OPERATION5. Starting the Tractor OPERATION 6. Pre-Operation Inspection and Service6.1 Tractor Pre-Operation Inspection/Service OPERATIONOPERATION 6.2 Loader Pre-Operation Inspection and ServiceOPERATION OPERATION OPERATIONOPERATION OPERATIONDO NOT OPERATE an UNSAFE TRACTOR or FRONT END LOADER OPERATIONOPERATION Tractor PRE-OPERATION InspectionDO NOT OPERATE an UNSAFE TRACTOR or FRONT END LOADER OPERATIONOPERATION FRONT END LOADER PRE-OPERATION InspectionOPERATION OPERATION7. Driving the Tractor and Loader 7.1 Starting the Tractor 7.2 Brake and Differential Lock SettingOPERATION OPERATION7.4 Operating the Tractor and Loader OPERATIONOPERATION 7.3 Driving the Tractor and LoaderOPERATION OPERATIONOPERATION OPERATIONOPERATION OPERATIONOPERATION OPERATIONFILLING THE BUCKET OPERATIONOPERATION 7.5 Operating the LoaderOPERATION OPERATIONNOTE Do not be concerned if the bucket is not completely filled during each pass. Maximum productivity is determined by the amount of material loaded in a given period of time. Time is lost if two or more attempts are made to fill the bucket on each pass CARRYING THE LOAD OPERATIONOPERATION LIFTING THE LOADOPERATION OPERATIONDUMPING THE BUCKET OPERATING WITH FLOAT CONTROL OPERATIONOPERATION LOWERING THE BUCKETOPERATION OPERATIONLOADING FROM A BANK OPERATION OPERATIONOPERATION OPERATIONPEELING AND SCRAPING OPERATION OPERATIONLOADING LOW TRUCKS OR SPREADERS FROM A PILE OPERATION OPERATIONBACKFILLING OPERATION OPERATIONOPERATION OPERATIONHANDLING LARGE HEAVY OBJECTS OPERATION OPERATION7.6 Operating Bale Spear OPERATION OPERATION7.7 Valve Lock Parking Stand OPERATIONOPERATION 8. Loader StorageOPERATION OPERATION9. Transporting the Tractor and Implement OPERATION OPERATIONOPERATION OPERATION9.1 Transporting on Public Roadways OPERATION OPERATION9.2 Hauling the Tractor and Implement TROUBLE 10. Troubleshooting GuideOPERATION OPERATIONMaintenance Section MAINTENANCE SECTIONMAINTENANCE MAINTENANCEMAINTENANCE MAINTENANCEGrease Fittings MAINTENANCEMAINTENANCE Lubrication ScheduleMAINTENANCE MAINTENANCEDaily Maintenance MAINTENANCE MAINTENANCEStorage MAINTENANCE MAINTENANCEMAINTENANCE MAINTENANCEProper Torque for Fasteners MAINTENANCE MAINTENANCEMAINTENANCE MAINTENANCEPage 1020 S Sangamon Ave RHINOLIMITED WARRANTY RHINOTO THE OWNER/OPERATOR/DEALER Printed U.S.A 1594 LOADER1594 -SOM-01/11 P/N F-4282C