OPERATION
8.1 Driveline Length Check
Before operating the Implement, check to make sure the Implement input driveline will not bottom out or become disengaged. Bottoming out occurs when the inner shaft penetrates the outer housing until the assembly becomes
When fitting the mower to the tractor, the telescoping driveline must be inspected to ensure that at its most compressed position, the profiles do not “bottom out”, and when at its farthest extended position, there is sufficient engagement between the profiles to operate safely. At its shortest length, there must be at least a 1” clearance between each profile end and opposite profile universal joint. At its farthest operating extension, a minimum profile engagement of 10” must be maintained.
“Bottoming Out” Check Procedure
•Disconnect driveline from the tractor and slide the profiles together until fully compressed.
•Place a mark on the inner shield 1/8” from the end of the outer shield.
•Reattach the driveline to the PTO Shaft.
•Raise the mower and watch the driveline as it approaches the mark. If the distance between the mark and the end of the outer shield tube becomes less than 2” at any point, the driveline must be shortened.
SE42 03/08 | Operation Section |
© 2008 Alamo Group Inc.
