Maintenance and Care
Maintenance and Care
Caring For Your SummerBreeze Zone Heater Cabinet
Clean the filter often for maximum performance (see filter maintenance, page 11). When necessary, wipe the cabinet clean with a soft cloth and/or furniture polish.
Storing Your SummerBreeze Zone Heater
When the heater is not being used for an extended period of time, follow these steps to extend the life and performance of the heater unit:
•Unplug the heater.
•Cover the heater to prevent dust from accumulating on or inside the unit.
•Store heater in a dry, low dust environment.
Note: Before resuming use of heater, ensure the filter and front grill are clean and clear of dust and dirt. Inspect the power cord to ensure no damage has compromised the integrity of the cord.
Suggestions for Best Performance
•Set your central heating system to a lower temperature. Place the zone heater in the area where you spend most of your time. Now set temperature on the zone heater to your comfort level.
•When heating larger areas, place the zone heater in a central location.
•Do not locate the zone heater in an area with a high air exchange rate. Heat produced should be contained in the room.
•Place the zone heater near a warmer inside wall and direct the output toward a cooler outside wall. The cooler outside wall will draw the generated heat toward it, which allows more efficient heating.
•Placing the zone heater next to a cold air return will draw the heat away from the area to be heated. Experiment with the placement of the heater to see what works best
for you.
•If the zone heater is used in an extremely dirty or dusty area, the filter should be cleaned more often to maintain the heater performance (see Filter Maintenance,
page 11).
Filter Maintenance
The only maintenance required for this zone heater is the periodic cleaning of the filter (located at the back of the unit). Vacuum or wash the filter at least once a month, or as dust becomes visible to ensure efficient operation of the heater.
•Turn the power off by pressing the on/off switch on the back of the heater to Off.
•Unplug the power cord from the electrical outlet.
•Remove the filter by gently pulling it straight out from the back of the heater.
•Clean the filter by vacuuming it until all dust and dirt is removed.
•Replace the filter by gently positioning it into the back of the heater.
•If filter is extremely dirty, run warm tap water over it until it is clean. Allow to dry completely, before replacing the filter back into the heater.
•Plug in the power cord and turn the power switch on the back of the heater to the on position.
|
| 6 | • |
|
50 | • | 0 | 70 | |
• |
|
|
| • |
40 |
|
|
| 8 |
|
|
| 0 | |
• |
|
|
| • |
|
|
|
| F° |
Electrostatic Filter
16 | 17 |
