Image Scanner User's Manual
¡ Setting the SCSI ID
Caution: E No two devices on the
E Do not set the SCSI ID to 8 or 9. The SCSI ID must be set between 0 and 7, even though 8 and 9 are present on the rotary switch.
E If more than two of this manufacturer’s scanners are connected to your system, you can not use SCAM. In this case, set the unique IDs for each scanners manually.
Installation
This scanner supports the SCAM standard. If your system also complies with this standard, set DIP switch 3 to OFF position (original position). The SCSI ID will be assigned automatically when power is next turned on. If your system does not comply with this standard, follow the steps below to set the ID manually.
1.Set DIP switch 3 to the ON positon.
2.Turn the rotary switch and set the number to the desired SCSI ID number.
3.If you change the SCSI ID while the scan- ner is on, reset the scanner by turning the power off and on, or pushing the reset switch.
1 | 2 | 3 | 4 | 5 | 6 | 7 | ON |
8 |
¡ Connecting the power cord
Caution: E Use the standard cable supplied with this unit. Otherwise, use cables that meet the re- quirements on page iv.
E Connect the power cable before turning the power switch on. E This product is equipped with a
The plug has a grounding pin and must be inserted into a grounded outlet.
1. | Make sure that the power switch is turned |
|
|
|
| off. |
|
|
|
2. | First, insert the power cable into the power |
|
|
|
| cord socket at the rear of the scanner. |
|
|
|
3. | Insert the other side of the power cord into |
|
|
|
| the plug receptacle. |
|
|
|
|
|
| - 7 | - |
Page 7 | 97.5.8, 5:35 PM | PageMaker 5.0J |
|
