OPERATION
CUTTING WARPED MATERIAL
See Figures 48 - 49.
When cutting warped material, always make sure it is positioned on the miter table with the convex side against the fence as shown in figure 48.
If the warped material is positioned the wrong way as shown in figure 49, it will pinch the blade near the completion of the cut.
RIGHT | Fig. 48 |
|
WRONG | Fig. 49 |
|
WARNING:
To avoid kickback and serious personal injury, never position the concave edge of bowed or warped material against the fence.
MAINTENANCE
WARNING:
When servicing, use only identical replacement parts. Use of any other part may create a hazard or cause product damage.
LUBRICATION
All of the bearings in this tool are lubricated with a sufficient amount of high grade lubricant for the life of the unit under normal operating conditions. Therefore, no further lubrica- tion is required.
WARNING:
Always wear safety goggles or safety glasses with side shields during power tool operation or when blowing dust. If operation is dusty, also wear a dust mask.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most plastics are susceptible to damage from various types of commercial solvents and may be damaged by their use. Use clean cloths to remove dirt, carbon dust, etc.
WARNING:
Do not at any time let brake fluids, gasoline, petro-
WARNING:
To ensure safety and reliability, all repairs should be performed by a qualified service technician at an authorized service center to avoid risk of personal injury.
Some areas will require infrequent lubrications. You will need to apply:
Automotive oil directly to the slide bars.
Light oil or a pressurized light spray oil to the arm pivot shaft.
Light oil or a pressurized light spray oil to the torsion spring.
35
