RIDGID R2740 Proper Hand Placement, Turning ON/OFF the Sander, Soft sTaRt feature, To F, Switch

OPERATION

VARIABLE SPEED CONTROL DIAL

See Figure 2.

The sander has a variable speed control dial, A (slowest) to F (fastest), designed to allow operator control of belt speed. To increase belt speed, turn the variable speed control dial to a higher setting. Turn to a lower setting to decrease belt speed. Refer to the chart on page 10 for proper speed selections.

PROPER HAND PLACEMENT

See Figure 3.

The front and rear handles allow two-handed operation which aids in maintaining control, keeping sander level with workpiece, and keeping hands clear of sanding belt. When carrying or operating the sander always hold the front handle with the left hand and the rear handle with the right hand as shown.

WARNING:

Keep hands and fingers clear of moving sanding belt, front pulley, and drive roller assembly. Failure to do so will result in the sanding of the hands or fingers possibly causing serious injury.

VARIABLE SPEED

CONTROL DIAL

(A TO F)

Fig. 2

WARNING:

Do not let your fingers rest over the front or right edge of the sander. If the sanding belt were to run off, or if it were not properly adjusted, your fingers could come in contact with the moving sanding belt resulting in possible serious injury.

TURNING ON/OFF THE SANDER

See Figure 4.

To turn on the sander: Depress the switch trigger.

To turn off the sander: Release the switch trigger.

Soft sTaRt feature

Soft start is a feature whereby the motor gradually ramps up to the selected top speed. For example, when a speed is selected with the speed limiting dial and the sander is stopped and then activated again, the sander will gradually ramp up to the previous speed setting once the switch trigger is pressed again.

11

REAR HANDLE

FRONT

HANDLE

KEEP HANDS AND FINGERS AWAY
FROM THESE AREAS AT ALL TIMES	Fig. 3

SWITCH

TRIGGER

Fig. 4