ADJUSTMENTS

repeat-a-cut

See Figure 17.

Plane a scrap piece of wood and measure the depth of the finished piece. If an adjustment is needed:

Unplug the planer.

Pull the replane indicator straight out to remove.

Using the hex key provided, remove the hex head screw from the depth adjustment handwheel. Remove the handwheel.

Remove the screws on the top and right side panel of the planer. Carefully lift and pull the side panel cover off.

Lower the cutterhead assembly until it stops against the stop screw.

Using an accurate ruler or a scrap piece of wood, check the measurement against the replane indicator setting.

If adjustment is necessary, use a wrench to loosen the lock nut and adjust the stop screw to the correct height.

Once the adjustment is made, retighten the lock nut and stop screw securely.

Replace the top and side panel, and secure using the set screw.

Replace the handwheel and hex head screw.

LOCK NUT

Replace the replane indicator.

 

REPLANE

INDICATOR

STOP SCREW

Fig. 17

22

Page 22
Image 22
RIDGID R4330 manual Repeat-a-cut, Replace the handwheel and hex head screw, Replace the replane indicator