ASSEMBLY
LEVELING THE TABLE EXTENSIONS
See Figure 9.
The infeed and outfeed table extensions are attached to the planer. Shipped in a folded, upright position, the table extensions must be in the down position before planing can begin. For accurate planing, table extensions must be level with the planer table.
NOTE: For optimum performance, always check to make sure the table extensions are level before beginning planing operations.
Place a straight edge or level across both the planer table and table extensions.
If adjustment is necessary, lift table extensions and loosen lock nuts. Adjust stop screws (one on each side) until extension table is level with planer table.
Press down on the table extension to ensure the table extension is properly seated.
Tighten lock nuts securely when adjustments are complete.
STOP
SCREWS
lock NUT
TABLE
EXTENSION
STRAIGHT
EDGE
TABLE
EXTENSION
PLANER
TABLE
Fig. 9
16
