OPERATION
TO INSTALL BITS
See Figures 6 and 7.
nUnplug your drill.
WARNING:
Failure to unplug your drill could result in accidental starting causing serious injury.
n Open or close the chuck jaws to a point where the opening is slightly larger than the drill bit you intend to use. Also, raise the front of your drill slightly to keep the drill bit from falling out of the chuck jaws.
nInsert drill bit into chuck the full length of the jaws.
WARNING:
Do not insert drill bit into chuck jaws and tighten as shown in figure 7. This could cause drill bit to be thrown from your drill resulting in possible serious personal injury or damage to your chuck.
nLoosen the chuck jaws from drill bit.
nTo loosen: grasp and hold the collar of the chuck with one hand, while rotating chuck body with your other hand.
NOTE: Rotate the chuck body in the direction of the ar- row marked RELEASE to loosen chuck jaws.
nDo not use a wrench to tighten or loosen the chuck jaws.
nRemove drill bit from chuck jaws.
DRILL BIT
CHUCK JAWS
CHUCK BODY
CHUCK COLLAR
nTighten the chuck jaws on drill bit.
nTo tighten: grasp and hold the collar of the chuck with one hand, while rotating the chuck body with your other hand.
NOTE: Rotate the chuck body in the direction of the ar- row marked GRIP to tighten chuck jaws.
nDo not use a wrench to tighten or loosen the chuck jaws.
TO REMOVE BITS
nUnplug your drill.
WARNING:
Failure to unplug your drill could result in accidental starting causing serious injury.
RIGHT
WRONG
Fig. 6
Fig. 7
11
