OPERATION
INSTALLING BITS
See Figure 10.
Lock the switch trigger by placing the direction of rotation selector in the center position.
Open or close the chuck jaws to a point where the opening is slightly larger than the bit size you intend to use. Also, raise the front of the drill slightly to keep the bit from falling out of the chuck jaws.
Insert the drill bit.
WARNING:
Make sure to insert the drill bit straight into the chuck jaws. Do not insert the drill bit into the chuck jaws at an angle then tighten, as shown in figure 11. This could cause the drill bit to be thrown from the drill, resulting in possible serious personal injury or damage to the chuck.
�Tighten the chuck jaws securely on the bit.
NOTE: Rotate the chuck body in the direction of the arrow marked LOCK to close the chuck jaws. Do not use a wrench to tighten or loosen the chuck jaws.
REMOVING BITS
See Figure 10.
Lock the switch trigger by placing the direction of rotation selector in the center position.
Open the chuck jaws.
NOTE: Rotate the chuck body in the direction of the arrow marked UNLOCK to open the chuck jaws. Do not use a wrench to tighten or loosen the chuck jaws.
Remove the drill bit.
BIT STORAGE
See Figure 12.
When not in use, bits provided with the drill can be placed in the storage area located on the rear base of the drill.
| UNLOCK | KEYLESS | |
| CHUCK | ||
DRILL BIT | (RELEASE) | ||
| |||
|
|
CHUCK 
JAWS
LOCK
(TIGHTEN)
CHUCK
BODY
RIGHT | Fig. 10 |
WRONG
Fig. 11
SCREWDRIVER BIT
BIT STORAGE AREA | Fig. 12 |
|
15
