RIDGID SP6490 manual Location and Function of Controls

Location and Function of Controls

	9
17	8
	7	1
	6	2
16	5	3
15	10	4
14

13
12	11

1.Belt Tension Handle...Turn handle counterclockwise to apply tension to belt, turn handle clockwise to release belt tension.

2.Head Lock Set Screws...Locks the head to the column. Always have them locked in place while operating the drill press.

3.Feed Handle...For moving the chuck up or down. One or two of the han- dles may be removed if necessary whenever the workpiece is of such unusual shape that it interferes with the handles.

4.Table Crank...Turn clockwise to ele- vate table. Support lock must be released before operating crank.

5.Chuck...Holds drill bit or other rec- ommended accessory to perform desired operations.

6.Depth Scale...Allows operator to adjust drill press to drill to a desired depth.

7.Drill “On-Off” Switch...Has locking feature to prevent unauthorized and possible hazardous use by children and others.

8.Light “On-Off” Switch...Turns the light on and off.

9.Depth Scale Lock...Locks the depth scale at selected depth.

10.Spring Cap...Provides means to adjust quill spring tension.

11.Table Lock...Allows table to be rotated in various positions and locked.

12.Table Bevel Lock...Locks the table in any position from 0°- 45°.

13.Bevel Scale...Shows degree table is tilted for bevel operations. Scale is mounted on side of arm.

14.Support Lock Handle...Tightening locks table support to column. Always have it locked in place while operat- ing the drill press.

15.Chuck Key...Used to tighten drill in the chuck and also to loosen the chuck for drill removal.

16.Storage Tray...Conveniently holds drill bits and other accessories.

17.Belt Tension Lock Handles...Tight- ening handles locks motor bracket support to maintain correct belt dis- tance and tension.

Note and follow the safety warnings and instructions that appear on the panel on the right side of the head.

12