Assemble the Detachable Blower for “Blowing”
This may be assembled three ways.
1.Insert the small end of one of the exten- sion wands into the blowing port of the detachable blower. Insert the male- male adapter into the extension wand and install the blower nozzle onto the
-OR -
2.Insert the
Blowing
Port
Blower Nozzle
male adapter.
3.The wet/dry vac may also be used for blowing using the seven foot hose sup- plied with the wet/dry vac. Install the male/male adapter in the blowing port of the wet/dry vac. The male/male adapter will insert into the inside of the push button end of the vac hose. Assemble the hose to the male/male adapter and connect the blower nozzle to the opposite end of the hose. The unit is ready for blowing applications.
4.Turn the blower “ON” by toggling the switch in the handle of the blower to the “ON” position.
Blower Nozzle
Male/Male
Adapter
Male/Male | Hose |
Adapter |
Maintenance
Blower Intake
WARNING: To reduce the risk of injury from accidental starting, unplug power cord before changing or cleaning filter or foam pad.
After using the detachable blower of your wet/dry vac, examine the bottom of the blower for dust and debris. Check to see if the intake to the blower has debris stuck to the plastic vents and foam pad.
To clean the foam pad under the intake shield of the detachable blower:
1.Remove the three screws holding the intake shield.
2.Lift the intake shield off and set aside.
3.Lift the foam pad away from the detached blower, the foam pad holder will also lift away from the blower.
4.Remove the foam pad from pad holder and set the foam pad holder to the side.
Foam Pad Holder
Foam Pad
Intake Shield
Screws (3)
Clean the foam pad in warm soapy water or brush debris away. Allow foam pad to dry.
5.Examine foam pad for reuse. If you need to replace it, check the service part section of this manual.
11