Vac Assembly
1.Locate the lid assembly and the drum/ caster foot/caddy assembly (assembled earlier).
2.Position the lid assembly with the inlet of the unit located in line with the drain cap on the dust drum.
3.To assemble the lid assembly to the drum/caster foot/caddy assembly, lower the lid assembly onto the dust drum. Rotate both latches down until you hear them snap over the lip of the drum.
Drum | Drum Latch |
Latch |
Drum Lip
Inlet
Lid
Assembly 
Dust
Drum
Drain
Cap
Positioning Detachable Blower (Power Head Assembly)
1.To remove the detachable blower from the lid assembly, press down on the power head latch under the detachable blower handle and lift the blower off the lid of the vac. To replace the blower back onto the lid assembly, Follow the instructions below.
2.On top of the detachable blower (oppo- site the handle side of the blower); there is a molded plastic lead that is used to assist assembling the unit. Position the lead into the indented area above the “Pull Handle”.
3.Rotate the detachable blower down until the travel of the unit stops.
4.Lightly press down on the carry handle of the detachable blower until you hear the slight “snap” of the power head latch engaging the blower. The detachable blower is now latched to the lid assembly.
Power
Head Latch
Detachable
Blower
Power Head
Latch
Drum
Latch
Lid Asm.
Molded
Plastic Lead
Indented Area
Pull
Handle
7
