Rimage 360i
Tip If you print on areas of the disc where the surface is not suitable for printing, the ink can smear or run.
Tip: The image below shows a disc with a stacking ring.
Tip: If you print on areas of the disc where the surface is not suitable for printing, the ink will smear or run.
Tip: Most discs with a printable hub and a stacking ring have the following printable areas:
Standard Area
Outer Diameter 118 mm
Inner Diameter 38 mm
Hub Area
Outer Diameter 35 mm Inner Diameter 24 mm
Changing or enabling masking
This functionality allows you to adjust the
1.Navigate to Printing Preferences (refer to page 9).
2.Select the Mask Settings tab.
3.To enable mask settings, select the Enable Masking checkbox.
4.Change the mask settings as desired.
5.When you have made the desired choices, select OK. The Disc Color 360i Properties window closes.
Note: Select the Default button to return mask settings to the factory settings.
Printing on hub with a stacking ring
This functionality allows you to print on the hub area of the disc. If your discs have a printable hub area, and there is a gap for the stacking ring, use this procedure.
1.Navigate to Printing Preferences (refer to page 9).
2.Change mask settings.
a.Select the Mask Settings tab.
b.Select the Enable Masking checkbox.
c.In the Hub Area Settings box, select the Printing on Hub checkbox.
3.Measure the printable area and adjust the settings.
a.Measure the inner diameter of the printable surface.
b.In the Hub Area Settings, enter the inner diameter that you measured in step a.
c.Measure the outer diameter of the printable hub area.
d.In the Hub Area Settings, enter the outer diameter that you measured in step c.
e.Measure the inner diameter of the standard printable area.
f.In the Standard Area Settings, enter the diameter that you measured in step e.
4.After you have entered the correct measurements, select OK. The Disc Color 360i Properties window closes.
12 | 110808_C |
