Tip: The image below shows a disc with no stacking ring.
Tip: Rimage recommends that you set the inner diameter so that it is 1 mm greater than the actual measurement to prevent the ink from smearing. The inner diameter on Rimage media is 23 mm. Set the inner diameter field to 24 mm.
Operate the Rimage 360i
Printing on hub without a stacking ring
This functionality allows you to print on the full surface of a disc that has no stacking ring. If you print on areas of the disc where the surface is not suitable for printing, the ink can smear or run.
1.Navigate to Printing Preferences (refer to page 9).
2.Change mask settings.
a.Select the Mask Settings tab.
b.Select the Enable Masking checkbox.
c.In the Hub Area Settings box, select the Printing on Hub checkbox.
3.Measure the printable area and adjust the settings.
a.Measure the inner diameter of the printable surface.
b.In the Hub Area Settings, change the Outer Diameter and Inner Diameter settings to the value measured in step a before changing any other diameter settings.
c.In the Standard Area Settings, change the Inner Diameter to the same value used in step b.
4.After you have entered the correct measurements, select OK. The
Disc Color 360i Properties window closes.
Aligning the ink cartridges
For optimal print quality and maximum printing speed, use this procedure to align the ink cartridges.
1.Navigate to Printing Preferences (refer to page 9).
2.At the Rimage 360i, open the front cover.
3.Press the green (middle) button. The printer tray opens.
4.Align the ink cartridges.
a.From the Disc Color Printer 360i Printing Preferences window, select the Service tab.
b.Select the Service ToolBox button. The Rimage Service Toolbox window opens.
c.Select the Align Cartridges button. The Align Cartridges for Disc Color 360i dialog box opens.
d.To align the ink cartridges, follow the instructions in the Align Cartridges for Disc Color 360i dialog box.
e.To close the Align Cartridges for Disc Color 360i dialog box, select OK.
5.To close the Disc Color 360i Printing Properties window, select OK.
6.To close the printer tray, press the green (middle) button. The printer tray closes.
7.Close the front cover.
110808_C | 13 |
