Maintain the Everest printer
110875_A 27

Clean the air filter

1. Power off the printer.
2. Remove the air filter.
a. At the rear of the Everest
printer, remove the two screws
holding the fan cover.
b. Remove the air filter.
3. Clean the air filter.
a. Use water to clean the air filter.
b. Allow the air filter to dry.
Screws
Fan cover
4. Prepare the printer for use.
a. When the air filter is dry, place it inside the fan cov er.
b. Use the two screws to attach the fan cover.
5. Power on the printer. The printer is ready.

Clean the platen roller with the Everest cleaning kit

- Important! Clean the platen roller only if you notice a diminished print quality, such as white

specks on the printed disc.
Before you begin:
A. Ensure that the printer is powered off.
B. At the back of the printer, change the mode
switch to position 3 (Diagnostic Mode).
C. Power on the printer.
Clean the platen roller:
1. Access the platen roller.
a. Press the two side cover latches to release the side cover.
b. Lower the side cover.
c. Open latches 1, 2, and 3.
d. Remove the print ribbon carrier. For specific instructions, see Changing the print
ribbon. Refer to page 21.
e. Pull out the retransfer ribbon carrier. For specific instructions, see Changing the
retransfer ribbon. Refer to page 23.

Note: The retransfer ribbon carrier cannot be removed from the printer.

2. To access and select diagnostic 1, press and hold the operator button for 2 seconds. The
platen roller rotates and the front panel Active indicator light blinks.