Ringdale 1543 manual Output Report, Feature Report, Control Commands

Output Report
Usage (Operational commands)	09 02
Report Count (8)	95 08
Output (Data, Variable, Absolute, Bitfield)	91 02
Feature Report
Usage (Configuration message)	09 03
Report Count (8)	95 08
Feature (Data, Variable, Absolute, Bitfield)	B1 02
End Collection	C0

CONTROL COMMANDS

Relay configuration data is read /set using the Feature Report via the Control Pipe (Endpoint 0)

Write = Set relay configuration

Read = Get relay configuration

cmd	0x00 = reply (to read config request)
data:	byte	reserved1;
	byte	configbits;
	byte	reserved2;
	32bit	duration;		// in 1/20 sec increments
cmd	0x01 = set config
data:	byte	reserved1;		// write 0
	byte	configbits;
	byte	reserved2;		// write 0
	32bit	duration;		// in 1/20 sec increments
configbits:
bit	7 Dev2		0=No SPP	1=SPP (side pressure pulsing)
	6 Dev1		0=No SPP	1=SPP (side pressure pulsing)
	5 Dev1		0=Pulsed	1=Standard
	4 Dev1		0=PTO Fail-Closed
				1=PTC Fail-Open
	3 Dev2		0=Bolt	1=Strike
	2 Dev1		0=Bolt	1=Strike
	1 Dev2		0=PTO Fail-Closed
				1=PTC Fail-Open
	0 Dev2		0=Pulsed	1=Standard

The configbits parameter is also used in various other Ringdale products. This device uses the same parameter to maintain compatibility with software that can control multiple devices. Only bit 4 is significant in this device. Please note that Power To Open

/Fail Closed and Power To Close / Fail Open are better achieved using the two relay wiring options, thus this value can be left at default 0x2D.

6