Rinnai RC98HPE High Altitude Installations, Connecting Multiple Water Heaters, Guidelines

High Altitude Installations

Set dip switches 2 and 3 to the values shown in table below for your altitude. The default setting for the appliance is 0-2000 ft (0-610 m) with switches No. 2 and No. 3 in the OFF position.

	0-2000 ft				2001-5200 ft					5201-7700 ft					7701-10200 ft
	(0-610 m)				(610-1585 m)					(1585-2347 m)					(2347-3109 m)
Switch No. 2		OFF					OFF					ON					ON
Switch No. 3		OFF					ON					OFF					ON
	Switch No.				Switch No.				Switch No.				Switch No.
			ON					ON					ON					ON
	O					O					O					O
				1					1					1					1
	F			2		F			2		F			2		F			2
	F					F					F					F
				3					3					3					3
				4					4					4					4
				5					5					5					5
				6					6					6					6
				7					7					7					7
				8					8					8					8

Connecting Multiple Water Heaters

The EZConnect™ cable is an optional accessory that connects 2 water heaters and allows them to function as one hot water source.

The MSA-2M and MSA-2S packs are optional accessories that connect 2 to 5 water heaters and allow them to function as one hot water source.

Refer to the instructions that come with the accessory for complete installation information.

Guidelines

•Do not install both the EZConnect™ and the MSA packs because they are not designed to operate together.

•Water heaters connected with the EZConnect™ Cable or the MSA-2M and MSA-2S packs cannot be used for the bath fill function.

•Water heaters should be installed less than 18 inches apart so that the cables will reach between units and to prevent temperature fluctuations (cold water sandwich effect) when the water is shut off and turned back on.

•Temperature settings can only be changed on the controller for the primary unit.

	Number of Connected Water Heaters:		Accessories Necessary:
	2		(1) EZConnect™ Cable or (1) MSA-2M
	3		(1) MSA-2M and (1) MSA-2S
	4		(1) MSA-2M and (2) MSA-2S
	5		(1) MSA-2M and (3) MSA-2S
32		Manual - Rinnai Condensing Water Heaters