Rinnai RCE-560PTR manual Tto

Test

Button

Normal OFF

Low Pressure Mode

e

c

n

n

o

o

n

t

t

o

u

t

t

B

u

1

B

t

r

es

s

e

e

o

tim

T

im

w

High Pressure Mode

tton t

T

u

t

B

es

n

T

to

ut

er 1 B

im

Test Mode

T

Test

B

u

tt

o

n

t

hree

ti

m

T

Ti

m

es

e

er

1

Butt

Decision Level

s

on

t

T

B

Adjustment Mode

ut

i

t

m

o

e

n

f

r

1

o

u

B

r

t

u

tto

i

m

n

e

s

Sensitivity

Selection Mode

The unit will go into Test Mode when the Test Switch is switched ON while the unit is operating. The unit will go into each of the following modes during Test Mode : Low Pressure Mode, High Pressure Mode, Decision Level Adjustment Mode, and Sensitive Selection Mode.

•	Test Mode	Disables the temperature controls and allows you to
		change the level manually. (Cancels when the test
		switch is turned on again, or when combustion ceases.)
		The level can be raised/lowered with the temperature
		control buttons “∧” and “∨”, however, if they are con-
		tinuously pressed for at least 0.5 seconds, it will change
		to level 12 or level 1.
•	Low Pressure Mode	The modulating valve electric current value for low
		combustion can be adjusted with the temperature “∧”
		and “∨” buttons. After adjusting, the data will be stored
		when Timer 1 is switched ON.
•	High Pressure Mode	The modulating valve electric current value for high
		combustion can be adjusted, with the temperature “∧”
		and “∨” buttons. After adjusting, the data will be stored
		when Timer 1 is switched ON.
• Decision Level Adjustment Mode		The maximum flame failure detection level can be
		adjusted with the temperature “∨” button, and the mini-
		mum with the temperature “∧” button. They can be set
		in the following order: 12mV, 14mV, 16mV, 18mV.
		After adjusting, the data will be stored when Timer 1 is
		switched ON.
•	Sensitivity Selection Mode	The sensitivity can be changed over from 1 to 2, and
		vice versa, with the temperature “∨” button. After

adjusting, the data will be stored when Timer 1 is switched ON. It is factory set at sensitivity level 2.

*To reset each mode, press the ON/OFF button to turn the unit OFF.

*If the Timer 1 button is not pressed during each mode, the updated setting will be cancelled and the data will not be stored in memory.

*If the data is stored, it will return to test mode and the entered information will be displayed.

Convector 460/560PTR - 30 - ©Rinnai