Writing (Burning) Files to a CD

Disk Spanning

The QuattroDrive supports disk spanning which means, when burning files from a Flash Memory Card to a CD-RW and the CD-RW becomes full, the Quattro- Drive will prompt you to insert a new CD-RW. After Inserting a new CD-RW, burning will automatically continue. This can be done up to four times in one burning session.

Writing from the Computer

1.Connect the QuattroDrive to a computer as described in Connecting to a Computer on page 5.

2.Use Nero ROM burning software or other burning software as you normally would.

Erasing a CD-RW

There are two methods which you can use to erase a CD-RW.

When the QuattroDrive is connected to a TV/projector, follow the steps below.

1.Insert a CD-RW as described in Inserting and Removing a CD on page 6.

2.Select the ERASE CD-RWmenu item as described in DISC SETUP on page 18 and select YES.

3.Wait until ERASE COMPLETED message appears on the screen and the CD-R/W LED stops flashing before continuing.

When the QuattroDrive is not connected to a TV/projector, follow the steps be- low.

1.Insert a CD-RW as described in Inserting and Removing a CD on page 6.

2.Press the STOP/ESC button on the QuattroDrive

to bring up the menu in the LCD panel.

3. Press the PREV and NEXT buttons until ErASE appears in the LCD panel.

4.Press the ENTER/PLAY button to enter this menu and Go will appear.

5.Press the ENTER/PLAY button to begin erasing

the CD-RW and ErASE will appear again. Wait until the End message or an error message (see Error Codes on page 29) appears before continu- ing.

6.Press the STOP/ESC button to get back to the main menu and again to exit.

28