SECTION 1: HEATER SAFETY
SECTION 1: HEATER SAFETY
Your Safety is Important to Us! This symbol is used throughout the manual to notify you of possible fire, electrical or burn hazards. Please pay special attention when reading and
following the warnings in these sections.
Installation, service and annual inspection of heater must be done by a contractor qualified in the installation and service of
Read this manual carefully before installation, operation or service of this equipment.
This heater is designed for heating nonresidential indoor spaces. Do not install in residential spaces. These instructions, the layout drawing, local codes and ordinances, and applicable standards that apply to gas piping, electrical wiring, venting, etc. must be thoroughly understood before proceeding with the installation. Protective gear is to be worn during installation, operation and service. Thin sheet metal parts, such as the reflector portion of the heater and the various venting components, have sharp edges. To prevent injury, the use of work gloves is recommended. The use of gloves will also
prevent the transfer of body oils from the hands to the surface of the reflector.
Before installation, check that local distribution conditions, nature of gas and pressure, and adjustment of the appliance are compatible.
For additional copies of the GORDONRAY® BH Installation, Operation and Service Manual, please contact
1.1 Manpower Requirements
To prevent personal injury and damage to the heater, two persons will be required for installation.
1.2 Safety Labels and Their Placement
Product safety signs or labels should be replaced by the product user when they are no longer legible. Please contact
labels. See Page 1, Figure 1through Page 2, Figure 2.
FIGURE 1: Top and Bottom Panel Label Placement
|
| Gas Connection Label |
| Top Panel |
|
|
| Vent Length Label |
|
| Logo Label |
Description | Part Number |
|
Logo Label | 91031100 |
|
Vent Length Label | 91039500 |
|
Gas Connection Label | 91018123 | Bottom Panel |
|
| |
|
| 1 |
