Operating your radio - FM auto-tune
1.Fully extend the wire aerial located on the rear of your clock radio. Place the wire antenna so that it is as straight as possible extending either above or below the radio.
2.Press the On / Standby button to switch on your clock radio.
3.Press the Band button to select the FM band.
4.Press and release the Auto Tune button. Your radio will scan from low frequency to high frequency (or in the direction last scanned). It will stop automatically when it finds a station of sufficient strength.
5.After a few seconds the display will update. The display will show the frequency of the signal found. If the signal is strong enough and there is RDS data present then the radio will display the station name.
Note that the radio will switch to the time display after 10 seconds if no buttons are pressed.
6.To find additional stations press and release the Auto Tune button as before.
7.To scan the FM band in an opposite direction press and hold down either the Tuning Up button (to scan low frequency to high frequency) or Tuning Down button (to scan high frequency to low frequency) and then press the Auto tune button again.
When the end of the waveband is reached your radio will recommence tuning from the opposite end of the waveband.
9. Adjust the Volume to the required setting.
2
3
Full
Auto Tune
4,6,7
SNOOZE
down | TUNING | up |
77
12
