BATTERY AND CHARGING
Amplifiers will put an increased load on the vehicle's battery and charging system. We recommend checking your alternator and battery condition to ensure that the electrical system has enough capacity to handle the increased load of your stereo system. Stock electrical systems which are in good condition should be able to handle the extra load of any Rockford amplifier without problems, although battery and alternator life can be reduced slightly. To maximize the performance of your Rockford Fosgate amplifier, we suggest the use of a heavy duty battery, high output alternator and an energy storage capacitor.
W I R I N G T H E S Y S T E M
CAUTION: Avoid running power wires near the low level input cables, antenna, power leads, sensitive equipment or harnesses. The power wires carry substantial current and could induce noise into the audio system.
•For safety, disconnect the negative lead from the battery prior to beginning the installation.
1.Configure the internal XCard crossovers prior to installation. Refer to “Using the XCard” (page 12) for further information.
2.Plan the wire routing. Take care when running signal level RCA cables to keep them close together but isolated from the amplifier's power cables and any high power auto accessories, especially electric motors. This is done to prevent coupling the noise from radiated electrical fields into the audio signal. When feeding the wires through the firewall or any metal barrier, protect them with plastic or rubber grommets to prevent short circuits. Leave the wires long at this point to adjust for a precise fit at a later time.
3.Prepare the Power cable for at-
tachment to the amplifier by strip- | STRIP WIRE |
|
|
| INSULATION | ||
|
| > | > | ||||
ping 5/8" of insulation from the |
|
|
|
|
|
| |
| < |
| > |
|
| ||
end of the wire. To prevent the |
| 5/8" |
|
| |||
|
|
|
|
| |||
|
|
|
|
|
| ||
wire from fraying, strip the insula- | AMP |
|
|
|
| ||
tion at a 45° angle. Insert the bared |
|
| > |
|
|
| |
|
|
|
|
|
| ||
wire into the B+ terminal with the |
|
|
|
|
|
| |
|
|
|
|
|
| ||
long side of the insulation on the |
|
|
|
|
|
| |
top. Bend the cable down at a 90° |
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
angle. Tighten the set screw to secure the cable in place. | |||||||
– 9 – |
|
|
|
|
|
| |
