
TROUBLESHOOTING
NOTE: If the error still continues after doing one of the easy remedies, before taking the unit to a service dealer, try reseting the system by pressing the reset button.
General
SYMPTOM | DIAGNOSIS | REMEDY | |
|
|
| |
Source Unit does | Voltage applied to Red and | Check battery, connections and fuses and | |
not turn on | Yellow wires is not between | repair or replace as necessary. If voltage is | |
| 10.8 and 16 volts or there is no | above +16 volts, have the electrical system | |
| voltage present | inspected by an authorized car service center. | |
|
|
| |
| Unit is not properly grounded | Check wiring and repair as necessary | |
|
|
| |
|
|
| |
No backlight | Detachable faceplate not | Detach faceplate and reinstall into chassis | |
illumination | properly connected |
| |
|
|
| |
Speakers pop | Auto antenna and remote B+ are | Check wiring and repair as necessary. Refer to | |
when turning | not configured properly | “Wiring the System” section of this manual for | |
Source Unit |
| further information | |
On/Off |
|
| |
Bad component in the signal | Check connections and bypass all | ||
| |||
| chain | components between the source unit and the | |
|
| amplifier. Connect one component at a time to | |
|
| determine the culprit. Connect this component | |
|
| to the Blue wire and check for pops. Repair or | |
|
| replace component as necessary | |
|
|
| |
Tuner fails to tune | Antenna is disconnected | Check connections and repair as necessary | |
any radio stations |
|
| |
|
|
| |
Tuner has poor | Antenna is disconnected or not | Check connections and installation of antenna | |
reception | properly grounded to vehicle | and repair or replace as necessary | |
|
|
| |
| Antenna cable is intermittent or | Disconnect antenna and test with known | |
| damaged | working antenna. If tuner works, check | |
|
| installation and repair antenna as necessary | |
|
|
| |
| Antenna is wrong type for | Consult your local Authorized Rockford | |
| AM/FM frequencies | Fosgate Dealer for proper antenna selection | |
|
|
| |
Disc will not load | Voltage applied to Red and | Check battery, connections and fuses, and | |
into Source Unit | Yellow wires is not between | repair or replace as necessary. If voltage is | |
(also see error | 10.8 and 16 volts or there is no | above +16 volts, have the electrical system | |
codes) | voltage present | inspected by an authorized car service center | |
|
| ||
|
|
| |
|
|
| |
Disc will not eject | Voltage applied to Yellow wire is | Check battery, connections and fuses, and | |
(also see error | not between 10.8 and 16 volts | repair or replace as necessary. If voltage is | |
codes) | or there is no voltage present | above +16 volts, have the electrical system | |
|
| inspected by an authorized car service center | |
|
|
| |
ERROR 1 | No initialization | Press the reset button | |
(Initialize Error) |
|
| |
Mechanism is jammed and | Repair the mechanism and | ||
| |||
| loading motor (or driving circuit) | loading motor (or driving circuit) | |
| is defective |
| |
|
|
|
20