Rockford Fosgate T1500-1bd manual Specifications, MODEL- Power

SPECIFICATIONS

MODEL- POWER			T500-1bd			T1000-1bd	T1500-1bd
Continuous		Power Rating (RMS) - Measured at 14.4 Battery Volts
4	Load Bridged		250 Watts x 1			350 Watts x 1	500 Watts x 1
2	Load Bridged		400 Watts x 1			650 Watts x 1	1000 Watts x 1
1	Load Bridged		500 Watts x 1			1000 Watts x 1	1500 Watts x 1
Dimensions:		Height	2.14" (5.42cm)			2.14" (5.42cm)	2.14" (5.42cm)
		Width	8.14" (20.68cm)			8.14" (20.68cm)	8.14" (20.68cm)
		Length	11.41" (28.97cm)			13.66" (34.69cm)	14.91" (37.86cm)
Battery Fuse Rating (Amp) External			100A			150A	200A
(Not Supplied)
	“A” Weighted Signal to Noise Ratio					≥80 dB
	Referenced to 1 Watt into 4 ohms
	“A” Weighted Signal to Noise Ratio					≥100 dB
	Referenced to rated output into 4 ohms
	Crossover Slope					24dB/octave Butterworth
	Crossover Frequency					variable from 35Hz to 250Hz
	Frequency Response					20Hz to 250Hz ±0.5dB
	Signal Voltage Adjustment Range					Variable from 150mV to 5V (RCA Input)
	Protection				Short circuit protection shut downs the amplifier in
				case of very low impedance or shorted speaker wires.
	Equalization PEQ (Punch Equalization)			Thermal switch shuts down the amplifier in case of overheating.
						Variable from 0dB to +18dB @ 45Hz
	Input Impedance					20K ohms
	Infrasonic Filter					Selectable 12dB/Octave, -3dB @ 28Hz
	Operating Voltage					9 to 16 Volts DC
	Balanced Inputs					Yes
	CMRR (Common Mode Rejection Ratio)					>55dB @ 1KHz
	Damping Factor					>200
	THD+N (Total Harmonic Distortion + Noise) (T500-1bd)					< 0.5% @ 1 ohm
	THD+N (Total Harmonic Distortion + Noise) (T1000-1bd)					< 0.7% @ 1 ohm
	THD+N (Total Harmonic Distortion + Noise) (T1500-1bd)					< 0.8% @ 1 ohm

These specifications are Amplifier Power Standard CEA-2006 Compliant

Specifications subject to change without notice

10