SPECIFICATIONS
MODEL- POWER |
|
| ||
Continuous Power Rating (RMS) - Measured at 14.4 Battery Volts | 1000 Watts x 1 | |||
4 | Load Mono |
|
| |
2 | Load Mono |
|
| 1800 Watts x 1 |
1 | Load Mono |
|
| 2500 Watts x 1 |
Continuous Power Rating (RMS) - Two Amplifiers in bdSYNC Configuration | ||||
2 | Load Bridged/Mono |
| 5000 Watts x 1 | |
Dimensions: | Height |
| 2.14" (5.44cm) | |
|
| Width |
| 8.14" (20.68cm) |
|
| Length |
| 21.875" (55.66cm) |
Battery Fuse Rating (Amp) External (Not Supplied) |
| 300A | ||
| “A” Weighted Signal to Noise Ratio |
| ≥70 dB | |
| Referenced to 1 Watt into 4 ohms |
| ||
| “A” Weighted Signal to Noise Ratio |
| ≥100 dB | |
| Referenced to rated output into 4 ohms |
| ||
| Crossover Slope |
|
| 24dB/octave Butterworth |
| Crossover Frequency (Low Pass Only) |
| variable from 35Hz to 250Hz | |
| Frequency Response |
| 20Hz to 250Hz ±0.5dB | |
| Signal Voltage Adjustment Range | Variable from 150mV to 5V (RCA Input) | ||
| Protection |
| Short circuit protection shut downs the amplifier in | |
|
|
| case of very low impedance or shorted speaker wires. | |
|
|
| Thermal switch shuts down the amplifier in | |
| Equalization PEQ (Punch Equalization) |
| case of overheating. | |
| Variable from 0dB to +18dB @ 45Hz | |||
| Input Impedance |
|
| 20K ohms |
| Infrasonic Filter |
| Selectable 12dB/Octave, | |
| Operating Voltage |
|
| 9 to 15.5 Volts DC |
| Balanced Inputs |
|
| Yes |
| CMRR (Common Mode Rejection Ratio) |
| >55dB @ 1KHz | |
| Damping Factor |
|
| >200 |
| THD+N (Total Harmonic Distortion + Noise) |
| < 1% @ 1 ohm | |
These specifications are Amplifier Power Standard
Specifications subject to change without notice
14
