INSTALLATION
|
|
| |
8. | Connect from source signal by plugging the RCA cables into the input jacks at the amplifier. |
| |
| CAUTION: Always ensure power is off or disconnected at the amplifier before |
| |
| connecting RCA cables. Failure to do so may cause injury, damage to the |
| |
9. | amplifier and/or connected components. |
| |
Connect the speakers. Strip the speaker wires 1/2" and insert into the speaker terminal and tighten |
| ||
| the set screw to secure into place. Be sure to maintain proper speaker polarity. DO NOT chassis |
| |
10. | ground any of the speaker leads as unstable operation may result. |
| |
Perform a final check of the completed system wiring to ensure that all connections are accurate. |
| ||
| Check all power and ground connections for frayed wires and loose connections which could cause | ||
| problems. Install inline fuse near battery connection. |
| |
NOTE: Follow the diagrams for proper signal polarity. | or | ||
| CAUTION: These amplifiers are not recommended for impedance loads below 1 | ||
| 2 | per bridged (strapped) amplifier pairs. |
|
Power
Connection
Single Amplifier Wiring
8
