TROUBLESHOOTING
2.Bypass any and all electrical components between the stereo and the amplifier(s). Connect stereo directly to input of amplifier. If noise goes away the unit being bypassed is the cause of the noise.
OR
3.Remove existing ground wires for all electrical components. Reground wires to different locations. Verify that grounding location is clean, shiny metal free of paint, rust etc.
OR
4.Add secondary ground cable from negative battery terminal to the chassis metal or engine block of vehicle.
OR
5.Have alternator and battery load tested by your mechanic.Verify good working order of vehicle electrical system including distributor, spark plugs, spark plug wires, voltage regulator etc.
SPECIFICATIONS
MODEL- POWER |
|
|
Continuous Power Rating (RMS) - Measured at 14.4 Battery Volts
4 
Load Per Channel
2 
Load Per Channel
4 
Load Bridged
2 
Load Bridged
Dimensions: Height
Width
Length
Battery Fuse Rating (Amp) External (Not Supplied)
“A” Weighted Signal to Noise Ratio Referenced to 1 Watt into 4 ohms
“A” Weighted Signal to Noise Ratio Referenced to rated output into 4 ohms
Crossover Slope Crossover Frequency Frequency Response
Signal Voltage Adjustment Range Protection
Equalization PEQ (Punch Equalization)
Input Impedance
Operating Voltage
Balanced Inputs
CMRR (Common Mode Rejection Ratio)
Damping Factor
THD+N (Total Harmonic Distortion + Noise)
120 Watts x 2 |
| 200 Watts x 2 |
200 Watts x 2 |
| 300 Watts x 2 |
400 Watts x 1 |
| 600 Watts x 1 |
STABLE |
| STABLE |
2.14" (5.42cm) |
| 2.14" (5.42cm) |
8.14" (20.68cm) |
| 8.14" (20.68cm) |
11.41" (28.97cm) |
| 13.66" (34.69cm) |
100A |
| 150A |
|
≥85 dB
≥105 dB
24dB/octave Butterworth
variable from 50Hz to 500Hz
20Hz to 20KHz ±1dB
Variable from 150mV to 5V (RCA Input)
NOMAD - Internal
limits power in case of overload, plus short protection.
Thermal switch shuts down the amplifier in case of overheating.
Variable from 0dB to +18dB @ 45Hz and/or
0dB to +12dB @ 12KHz
20K ohms
9 to 16 Volts DC
Yes
>55dB @ 1KHz
>200
< 0.1 @ 2 ohm and < 0.05 @ 4 ohm
These specifications are Amplifier Power Standard
Specifications subject to change without notice
10
