Connecting Cronus to source components:

The input connections to the Cronus are made via RCA jacks on the rear of the amplifier. See figure 2. Be sure to use high quality interconnect cables – they do make a difference

 

Main Fuse

Right Channel

Left Channel

Binding Post

Binding Post

RCA

Variable and

Inputs

Fixed Outputs

 

Figure 1. Rear panel layout

Connecting Cronus to a turntable:

The phono section provided in the Cronus is suitable for a wide variety of cartridges. Best results will be obtained with moving magnet (mm) and high output moving coil (mc) cartridges. The cartridge loading is preset at 47K ohms with 150pF of capacitance.

Connecting Cronus to headphones :

The headphone jack is located on the front faceplate of the preamplifier, as shown in figure1. The Cronus headphone jack provides for a ¼” or 6mm headphone connector. If you have headphones with a different size connector, you can use a suitable adapter. It is normal for a small amount of sound to come out of the loudspeakers when the headphones are plugged in.

Connecting Cronus to the power outlet:

Connect the IEC send of the detachable power cord provided to the amplifier, and plug the opposite end into corresponding outlet. It is recommended that both Cronus’ and all sources (CD, tuner, etc.) are plugged into the same wall outlet if possible (perhaps using a power outlet strip). This is to avoid creating a ground loop.

Amplifier Location:

The Cronus is an open tube design and depends on natural convection flow patterns for proper cooling. To ensure proper cooling, the unit should be located in a position so that the airflow is not impeded. In addition, the unit should not be placed in an enclosed shelf, and should have a minimum of 6 inches of free space above it.

4

Page 4
Image 4
Rogue Audio Connecting Cronus to source components, Connecting Cronus to a turntable, Connecting Cronus to headphones