Roksan Audio KMA-2/3 user manual T R O U B L E S H O O T I N G, Guarantee, Symptom, Likely Cause

T R O U B L E S H O O T I N G K a n d y Power Amplifier 2/3 Channel

If you suspect that your ROKSAN Kandy Power Amplifier is not operating properly, you should check all the connections carefully. Pay particular attention to speaker phasing and channel connections. Phono plugs should be fully inserted- a frequent cause of problems is that Phono plug surrounds do not make proper contact. Below are some commonly encountered problems with suggestions for possible cure. The list is not exhaustive: If you have any unresolved problems, please consult your appointed ROKSAN dealer or distributor.

SYMPTOM	LIKELY CAUSE	SUGGESTED REMEDY
No power	AC Mains lead not inserted properly	Ensure AC Mains lead is fully inserted
	Unit not switched on at rear panel	Switch unit on at rear panel
No output on one or more	Missing or bad input signal connection	Check all input connections
channels	Incorrect speaker connection	Check speaker output connections on
		rear panel
Lower output on one or	Higher trim on one or more channels	Check trim level and adjust accordingly
more channels
Poor speaker imaging, lack	Loudspeakers connected out of phase	Check polarity of speaker connections
of Bass output		(especially important if Multi-wiring,
		Multi-amping)
Hum from speakers	Incorrect Grounding	Check Mains polarity and grounding on
		all connected equipment

GUARANTEE K a n d y Power Amplifier 2/3 Channel

There are no user-serviceable parts inside your Kandy Power Amplifier. If a fault should develop, refer any servicing to your appointed ROKSAN dealer, distributor or ROKSAN approved service agent.

Your ROKSAN Kandy Power Amplifier is guaranteed against any defect in materials and workmanship for a period of two years from the date of purchase.

This guarantee only becomes effective if the warranty card is validated by the ROKSAN retailer from whom the equipment was purchased and returned to ROKSAN within 28 days of purchase.

This guarantee excludes:

1.Damage caused due to accident, missuse, neglect and incorrect installation, adjustment or repair.

2.Liability for damage or loss during transit from the retailer or purchaser to ROKSAN or its authorised distributor for the purposes of repair or inspection.

Carriage costs to ROKSAN shall be borne by the consignor.

All claims under this guarantee must be made through an authorised ROKSAN retailer.

If equipment returned for repair to ROKSAN is found on inspection to comply with the product specification ROKSAN reserves the right to make a charge for examination and return carriage.

Unauthorised servicing will void this guarantee.

Roksan Audio ltd	Kandy Power Amplifier 2/3 Channel User Manual
CLASSIFICATION: General Use	Version 1.0

All specifications are liable to change without notice. E&OE Page 9 of 10 ENGLISH