Feature Reference

NOTE:

Although you can change the setting for Backup Programming— Automatic (#123) without having a Backup/Restore in the PC Card slot, you must have a PC Card in the slot before a backup can take place.

The same Backup/Restore PC Card can be used for both automatic and manual backups, since the data is recorded in two separate files. An automatic backup replaces the AUTO.mmddyy file only (where mmddyy represents the date of the backup in month, day, year format), and a manual backup replaces the MAN.mmddyy file only. Restore Programming (#125) asks you to specify which backup file you want to use.

Calls will continue to be handled normally during an automatic backup.

Valid Entries

1 = Active

2 = Not Active

3 = Backup Alarm Cleared

Programming

(See Figure 2-2on page 2-19for the location of special programming buttons such as sand eon system phones.)

Changing the Setting

To change the setting for Backup Programming—Automatic:

1.Press f00ss#1 23at extension 10 or 11.

The current setting is displayed.

2.Press Dor dto change the setting, or press rto return the setting to the default.

3.Exit programming mode.

If you chose Option 1, Active:

The system will be backed up to the PC Card at 2:00 a.m., and thereafter at 2:00 a.m. on the first day of each month, provided that a valid Backup/Restore PC Card is in the PC Card slot. (See PARTNER PC Card Installation Instructions.)

The old AUTO.mmddyy file on the PC Card is replaced by the new one. (The MAN.mmddyy file is unaffected.) You can use the Restore Programming (#125) feature to check the date on the AUTO.mmddyy file to verify that the backup was successful.PPP

If you chose Option 2, Not Active, no automatic backups will be performed.

Using

Use Option 3 to clear Backup-Failure Alarms. See Clearing a Backup-Failure

Alarm in Chapter 6, “Troubleshooting.”

5-38

Page 137
Image 137
Lucent Technologies 518-458-100 manual Changing the Setting, Current setting is displayed, Alarm in , Troubleshooting