Feature Reference

Programming

(See Figure 2-2on page 2-19for the location of special programming buttons such as sand eon system phones.)

To program a VMS Cover button:

1.Press f00sscat extension 10 or 11.

2.Enter the number of the extension to be programmed with this feature.

3.Press a programmable button with lights.

4.Press f15.

5.Program another button for this extension or exit programming mode.

Using

From a system phone, press the programmed button to turn VMS Cover on; press it again to turn it off. Use the button like a switch—when the light is on, VMS Cover is on and your unanswered intercom and transferred calls or outside calls on lines assigned ownership go to your voice mailbox after the specified number of VMS Cover Rings.

If you turn on VMS Cover while a call is ringing, the call is sent immediately to your voice mailbox.

If VMS Cover is already on and a call begins to ring, you can turn on Do Not Disturb to send that call and any subsequent calls immediately to your voice mailbox.

5-220

Page 319
Image 319
Lucent Technologies 518-458-100 manual Programming, 220