Lucent Technologies 518-458-100 manual 398

Feature Reference

■PARTNER-6 phones have only four buttons available for lines, pools, and/or Auto Dial numbers.

■A combined total of 576 outside Auto Dial and Personal Speed Dial numbers can be programmed.

■For PBX or Centrex systems that require a dial-out code to make calls outside the PBX or Centrex system, include the dial-out code followed by one or more pauses (if available) on an Auto Dial button for a number outside the PBX or Centrex system. (See “Changing Settings to Support PBX or Centrex Services” in Chapter 2 for more information.)

Examples

The examples below show some possible entries for an Auto Dial number in Step 4 of “Programming” below.

■Outside Phone Number. Enter the phone number (up to 28 digits) exactly

as you would dial it. For example, to program 555-2398, press 5552

398.

■Extension Number. Press the left ibutton and enter the two-digit extension number. Press *before the extension number to program the Auto Dial button to voice signal an extension. For example, to program extension 20 for voice signaling, press i*20. The display reads:

Intercom *20

■Feature Code. Enter the appropriate code. For example, to program a button to turn on the message light at extension 20, press f092 0. When you press the programmed button, the Message Light at extension 20 turns on.

Programming

(See Figure 2-2on page 2-19for the location of special programming buttons such as sand eon system phones.)

To program an Auto Dial button:

1.Press f00sscat extension 10 or 11.

2.Enter the number of the extension to be programmed.

3.Press a programmable button.

4.Enter an outside phone number, feature code, or PBX/Centrex feature access code; or press left iand enter an extension number.

5.Repeat Steps 3 and 4 to program additional Auto Dial buttons, or exit programming mode.

5-14