Lucent Technologies 518-458-100 manual Press e

Feature Reference

Programming

(See Figure 2-2on page 2-19for the location of special programming buttons such as sand eon system phones.)

To begin a manual backup of system settings:

1.Verify that a Backup/Restore Card is in the processor module.

2.Press f00ss#1 24at extension 10 or 11.

If there is a problem, see Chapter 6, ‘‘Troubleshooting,’’, for explanations and corrective actions.

Otherwise, the display instructs you to press eto begin the backup.

3.Press e.

A status message is displayed indicating that a backup is in progress, and within 30 seconds, a message displays indicating the result.

If the backup was successful, the new backup information replaces the information in the old MAN.mmddyy file on the Backup/Restore PC Card and the.mmddyy extension now reflects the current date. Backup information created during a manual backup does not overwrite any AUTO.mmddyy file. Go on to Step 4.

If the backup failed and the display shows an error message, go to Step 4 and then see Chapter 6, ‘‘Troubleshooting,’’, for explanations and corrective actions.

4.Exit programming mode.

NOTE:

If you exit the procedure before the backup finishes, you will not interrupt the backup, but you will not see feedback messages on the display.

5-40