Lucent Technologies 518-458-100 manual Press c. The following appears on the display

Programming

34-button phones in the system, you must use a 34-button display phone to program since an 18-button phone cannot be used to program a 34-button phone.

To program a phone from extension 10 or 11, use the following procedure:

1.Place the Programming Overlay over the dialpad of the system display phone at extension 10 or 11—see ‘‘Programming Overlays’’ on page 2-17for more information.

2.To start programming:

a. Press f00. The following appears on the display:

PROGRAM EXT 10

(If you are programming from extension 11, “11" displays instead of “10.”)

b. Press s. The following appears on the display:

10 Enter Ext name

This display is for the Extension Name Display feature. When you are entering Centralized Telephone Programming mode, skip it by moving on to Step 2c.

c.Press sagain. The display reads:

SYSTEM PROGRAM

d.Press c. The following appears on the display:

CENTRAL TEL PROG

Extension:

3.Dial the extension number of the telephone to be programmed.

The green lights next to buttons on which lines or pools are assigned show the current Line Ringing settings; remaining buttons can be programmed with telephone numbers, extension numbers, or system features.

4.At this point, you can:

■Use Automatic Line Selection to change the order in which the telephone selects a line or pool when the user picks up the handset. (If you want to change Automatic Line Selection for an extension, you must do so immediately after you enter programming mode and dial the extension number.)

■Use Extension Name Display to assign a user’s name to the extension. See Chapter 5 for the character codes. (Like Automatic Line Selection, this procedure must be done immediately after you enter programming mode and dial the extension number. If you want to change both Automatic Line Selection and Extension Name Display, first change Automatic Line Selection, then press c, redial the extension number, then use Extension Name Display.)

■Use Line Ringing to change the ringing for an individual line or pool.

2-28