Lucent Technologies 518-458-100 manual Using, 163

Outgoing Call Restriction Button (#114)

Programming

(See Figure 2-2on page 2-19for the location of special programming buttons such as sand eon system phones.)

To program an Outgoing Call Restriction button at extension 10:

1.Press f00ss#11 4at extension 10 or 11.

2.At this point:

■If you want to assign Outgoing Call Restriction to the first available button, press Duntil the following appears on the display:

CallRstr Button

1Assigned-Ext10

■If you want to remove the Outgoing Call Restriction button assignment, press Duntil the following appears on the display:

CallRstr Button

2 Not Assigned

■If you want to assign Outgoing Call Restriction to a specific button, press 3. The following appears on the display:

CallRstr Button

3 Select Button

Then press a programmable button with lights to assign Outgoing

Call Restriction to that button.

3.Select another procedure or exit programming mode.

4.Label the Outgoing Call Restriction button at extension 10.

Using

To change an extension’s Outgoing Call Restriction setting:

1.Press the Outgoing Call Restriction button at extension 10.

The green light next to the Outgoing Call Restriction button turns on and extension 10 appears busy to the system.

2.Press the Auto Dial button for the desired extension repeatedly until its lights show the correct setting as follows:

■No Restriction. The green light next to the Auto Dial button is on steady.

■Inside Only. The red light next to the Auto Dial button is on steady.

■Local Only. The green light next to the Auto Dial button flashes.

5-163