Programming

You use the following special buttons while programming:

Nand Pcycle forward and backward through the programming procedures. You can use these buttons to select a procedure.

(If a procedure instructs you to press NP, pressing these buttons one after the other enables you to repeat the current programming procedure.)

nand pcycle forward and backward through a procedure’s parameters. A parameter is typically an outside line, a pool, an extension, or a telephone list entry.

Dand dcycle forward and backward through the valid entries. These buttons work only for fixed data, such as a line or extension number. They do not work for variable data such as date, time, password, telephone numbers, or doorphone assignments.

rreturns the current setting to the factory setting. When using Line Assignment (#301), removes lines from an extension; when using Pool Extension Assignment (#314), removes pools from an extension.

eends an entry of variable length, such as a telephone number in an Allowed Phone Number List.

sstarts the System Programming process.

cstarts the Centralized Telephone Programming process (to customize individual telephones centrally from extension 10 or 11).

fwhen followed by 00, enters or exits programming mode.

wenters a “wildcard” (a character that matches any digit dialed) in telephone numbers in Allowed Phone Number Lists (#407) and the Disallowed Phone Number Lists (#404).

2-18

Page 47
Image 47
Lucent Technologies 518-458-100 manual