Lucent Technologies 518-458-100 manual Pull to Remove Push to Insert

Battery Replacement

3.Pull the batteries straight out of the metal spring clips (see Figure 6-3), and dispose of the batteries properly.

! CAUTION:

Do not dispose of batteries in fire. Do not recharge, disassemble, install backwards, or mix with used or other battery types—batteries may explode or leak and cause a burn injury.

Pull to

remove

Push to

insert

Figure 6-3. Removing or Inserting Batteries in the Battery Assembly

4.Insert two new AAA-size standard alkaline batteries into the metal spring clips by pushing them straight in, placing the negative (–) end of one battery into the bottom clip, and the positive (+) end of the other battery into the top clip.

5.With the locking latch in the unlocked position (battery icon and “minus” icon visible), slide the battery assembly into the processor module along the battery guides on the inside of the battery compartment (see Figure 6-4).

Locking Latch

Tab

Figure 6-4. Inserting Battery Assembly and Batteries into Battery Compartment

6.Make sure the battery assembly is pushed in far enough that the edges of the assembly slip behind the plastic housing of the processor module.

6-7