Lucent Technologies 518-458-100 manual Considerations for Hunt Group, 122

Feature Reference

line covered by the PARTNER MAIL’s Automated Attendant Service, the PARTNER MAIL system recognizes that it is a fax call and automatically transfers it to the first available fax machine in the group.

Considerations for Hunt Group 7

This Hunt Group is used exclusively for the extensions associated with the voice messaging system hardware. Do not assign any other extensions to this group. A voice messaging system requires special hardware and set up procedures—refer to Voice Messaging Systems and to the documentation shipped with the voice messaging system for more information.

NOTE:

When using the PARTNER MAIL system, you can only use the bottom two ports of the PARTNER Endeavor 362 processor module or 362EC expansion module.

Valid Entries

1 = Assigned to group

2 = Not Assigned to group ✔

Programming

(See Figure 2-2on page 2-19for the location of special programming buttons such as sand eon system phones.)

To assign extensions to a Hunt Group:

1.Press f00ss#50 5at extension 10 or 11.

2.At the Group: prompt, enter a group number (1–7). For example, to select group 1, press 1. The following appears on the display:

Hunt Group 1

Extension:

3.Enter the desired extension number. For example, to select extension 31, press 31.

4.To assign or unassign the extension, press Duntil the appropriate value displays.

5.At this point:

■To assign or unassign another extension, press nor p until the extension number shows on the display. Repeat Step 4.

■To program another group, press NP, enter a new group number, and repeat Steps 3 and 4.

6.Select another procedure or exit programming mode.

5-122