Lucent Technologies 518-458-100 manual Using, 225

Voice Interrupt on Busy (#312)

■Any party involved in a voice interrupt on busy call cannot be involved in a second voice interrupt on busy call until the first is finished.

Valid Entries

1 = Assigned

2 = Not Assigned ✔

Programming

(See Figure 2-2on page 2-19for the location of special programming buttons such as sand eon system phones.)

To change the Voice Interrupt On Busy setting for an extension:

1.Press f00ss#31 2at extension 10 or 11.

2.Enter the number of the extension to be programmed with this feature.

3.To assign or unassign Voice Interrupt On Busy, press Duntil the appropriate value displays.

4.Select another procedure or exit programming mode.

Using

To initiate a voice interrupt on busy call:

1.From a system phone, press i.

2.Press *plus a two-digit extension number (or use an Auto Dial button).

3.Listen for one of the following responses:

■If you hear one beep, you have reached an idle system phone. You can speak after the beep.

Your voice is heard through the other extension’s speaker. If the recipient is present, he or she can reply.

■If you hear two beeps, you have reached a busy system phone with Voice Interrupt On Busy Assigned. You can speak after the beeps. Be aware that the third party to whom the recipient is speaking probably also will hear the two beeps and the faint sound of your voice.

If the recipient has a Voice Interrupt On Busy Talk-Back button, wait for a response. If you hear a second set of beeps, the recipient has ended the voice interrupt on busy call. In either case, hang up to end your part of the voice interrupt on busy call.

■If you hear ringing, you have reached a standard phone, an idle TransTalk 9000-series phone, or a system phone that is idle, has Do Not Disturb turned off, and has Voice Interrupt On Busy Not Assigned. Your call is not completed until someone answers.

5-225