Lucent Technologies 518-458-100 manual Touch-Tone Enable F08, 210

Feature Reference

Touch-Tone Enable (F08)

Description

This feature is available only on system phones.

This feature lets a system phone user send touch-tone signals on an outside call over a rotary line. For example, a user may need to dial touch-tone digits while on a call to a bank-by-phone service.

Related Procedures

■You must use Dial Mode (#201) to identify rotary lines to the system.

■To activate this feature from within a number stored on an Auto Dial button or as part of a Speed Dial number, press &when storing the number— see Special Dialing Functions.

Considerations

■This feature is needed only when dialing on a rotary line.

■Use Touch-Tone Enable only after a call is connected. For example, use this feature after dialing a bank-by-phone service that requires you to dial touch-tone digits.

■You can program a Touch-Tone Enable button on a system phone to turn on Touch-Tone Enable with one touch.

Programming

(See Figure 2-2on page 2-19for the location of special programming buttons such as sand eon system phones.)

To program a Touch-Tone Enable button:

1.Press f00sscat extension 10 or 11.

2.Enter the number of the extension to be programmed with this feature.

3.Press a programmable button.

4.Press f08.

5.Program another button for this extension or exit programming mode.

Using

From a system phone, press the programmed button or press f08when you need to enter touch-tone digits. Touch-Tone Enable stays in effect until you hang up.

5-210