Lucent Technologies 518-458-100 manual Message Light On F09XX, 149

Message Light On (F09XX)

Message Light On (F09XX)

Description

This feature turns on the message light at a specified extension (where XX is a system extension number).

Related Features

■For instructions on turning off the message light, see Message Light Off (F10XX).

■You may be able to use this feature to signal someone at a doorphone extension. See Doorphone Extension (#604 and #605).

Considerations

■This feature turns on the message light on system phones and standard phones that have message lights. (See Standard Telephones for a list of standard phones that have message lights.)

■For message-waiting capability, standard phones with LED-compatible message-waiting lights must be connected to the PARTNER Endeavor 362 processor or 362EC expansion module.

■On a standard phone, the message light flashes (only when the phone is idle) to indicate that the extension has received a message. Standard phones can be used to make calls when plugged into any port of the PARTNER Endeavor 362 processor or 362EC expansion module. However, standard phones will ring only when plugged into the Tip Ring ports, which are the bottom two ports.

■Do not use this feature for an extension that is covered by the voice messaging system. The voice messaging system automatically turns on the message light at a subscriber’s extension when a message is left in the mailbox.

■If you use this feature to signal someone at a doorphone extension, you must use Message Light Off to turn the light off.

■You can program a Message Light On button on a system phone to turn the message light on at a specific extension with one touch.

Programming

(See Figure 2-2on page 2-19for the location of special programming buttons such as sand eon system phones.)

To program a Message Light On button:

1.Press f00sscat extension 10 or 11.

5-149